Enabling/Disabling the Gesture Pads
You can enable/disable the gesture pads in accordance with your intended use. This setting will be applied to all profiles.
You can enable/disable the gesture pads in the following ways:
Switching temporarily with key operation
You can enable/disable the four gesture pads respectively by operating the keys. The settings are not saved to the keyboard. Turning the power off then on again will restore the settings to those set by the DIP switch or Keymap Tool.
By default, no key operation is assigned to enable/disable the gesture pads. To use this function, you will need to assign the operation to any key using Keymap Tool.
When the gesture pads are switched to be enabled/disabled, the LED indicator status changes according to the gesture pad settings.
Each LED indicator light from the left shows the setting status of the gesture pad on the left side, front left side, front right side, and right side, respectively.
Enabled: lights up once in white
Disabled: turns off
The figure above shows an example of the LED indicator when only the gesture pad on the left side is enabled and the others are disabled.
If the gesture pads are disabled in the DIP switch settings, the gesture pads will be disabled at all times, regardless of the settings by the key operation.
By default, the gesture pads are enabled in the DIP switch settings.
Setting with the DIP switches
To maintain the setting to enable/disable the gesture pads even after the keyboard is turned off and then on again, use the DIP switches on the base of the keyboard. The settings are saved to the keyboard.
When the setting to enable/disable the gesture pads is changed with the DIP switch, the setting is applied to all the gesture pads.
Be sure to turn off the power before setting any of the DIP switches.
Slide the cover on the base of the keyboard in the direction of
and lift it up in the direction of 
to remove it.
When lifting or moving the keyboard, be sure to hold the keyboard with both hands.
Change the DIP switch SW2 setting to enable/disable the gesture pads.
Use a tool such as a flathead screwdriver to change the DIP switches to [Up(ON)]/[Down].
All switches are set to [Down] as the factory default.
DIP Switch
SW2
Description
Gesture pad
Up(ON)
Disabled
Down
Enabled
Attach the cover back.
Close the cover firmly.
Setting with Keymap Tool
You can enable/disable the four gesture pads respectively in the window of Keymap Tool. The settings are saved to the keyboard.
You can also save the settings in the keymap config file.
If the gesture pads are disabled in the DIP switch settings, the gesture pads will be disabled at all times, regardless of the Keymap Tool settings.
By default, the gesture pads are enabled in the DIP switch settings.